@article { author = {Moradi, Shahrouz and Ramezani, Elias and Alijanpour, Ahmad and Banej Shafiei, Abbas}, title = {Quantitative and qualitative characteristics and altitudinal zonation of Arasbaran forest protected area, northwestern Iran}, journal = {Iranian Journal of Forest and Poplar Research}, volume = {24}, number = {3}, pages = {540-529}, year = {2016}, publisher = {Research Institute of Forests and Rangelands of Iran}, issn = {1735-0883}, eissn = {2383-1146}, doi = {10.22092/ijfpr.2016.107390}, abstract = {Knowledge on silvicultural characteristics of forest stands is prior to any forest management practice. The objectives of this study were to determine the forest types and to explore some quantitative and qualitative characteristics of Arasbaran forest protected area along an altitudinal gradient. Therefore, circular plots of 400 m2 at 50-meter elevation intervals were established along five altitudinal transects, 100 meters apart, from the lowest (1100 m a.s.l) to the highest (1725 m a.s.l) forest limit. In each plot, the physiographic conditions including slope gradient, altitude and geographic coordinates were determined. Woody species were identified and the diameter at breast height (dbh) of all trees above 7.5 cm dbh, as well as origin, health status, number of stems and tree leaning were measured. In addition, the regeneration frequency of each individual tree taller than 1.30 m in three diameter classes (0-2.5, 2.5-5 and 5-7.5 cm dbh) and shorter than 1.3 m in three height classes (0-10, 10-50 and 50-130 cm) were examined within 100 m2 regeneration plots. Four forest types including Carpinus betulus - Quercus petraea (1100-1400 m a.s.l), C. betulus - Q. petraea - Acer campestre- Fraxinus excelsior (1400-1500 m a.s.l), C. betulus - Q. petraea - A. campestre (1500-1650 m a.s.l) and C. betulus - Q. macranthera (1650-1725 m a.s.l) were distinguished along the altitudinal gradient. The highest number of stems per ha (mature and regeneration stands) and average basal area were observed in C. betulus - Q. macranthera type, whereas the highest average dbh was recorded in C. betulus - Q. petraea forest type. Finally, seed regeneration was most common in C. betulus - Q. petraea - A. campestre forest type.}, keywords = {Altitudinal gradient,Arasbaran,physiography,quantitative and qualitative characteristics,regeneration}, title_fa = {بررسی کمی و کیفی و پهنه‌بندی ارتفاعی توده‌های جنگلی منطقه حفاظت‌شده ارسباران}, abstract_fa = {شناخت ویژگی‌های جنگل‌شناسی توده‌های جنگلی مقدم بر هرگونه اقدام مدیریتی در جنگل است. پژوهش پیش‌رو با هدف تعیین تیپ‌های جنگلی و بررسی ویژگی‌های مهم جنگل‌شناسی توده‌ها در امتداد گرادیان ارتفاعی جنگل‌های حفاظت‌شده ارسباران انجام شد. بدین‌منظور، قطعه‌نمونه‌های دایره‌ای‌شکل 400 متر مربعی در فواصل ارتفاعی 50 متری، در امتداد پنج خط‌نمونه به فاصله 100 متر از یکدیگر، از پایین‌ترین حد (1100 متر) تا بالاترین حد (1725 متر) گسترش جنگل پیاده شدند. در هر قطعه‌نمونه، پس از تعیین عامل‌های فیزیوگرافی (شیب، جهت دامنه، ارتفاع و مختصات جغرافیایی)، گونه‌های گیاهی چوبی شناسایی و قطر برابر سینه کلیه درختان، مبدا درختان، وضعیت سلامت، تعداد تنه و وضعیت تنه نسبت به سطح افق اندازه‌گیری و تعیین شد. همچنین در مرکز هر قطعه‌نمونه اصلی، یک قطعه‌نمونه 100 متر مربعی پیاده شد و فراوانی زادآوری‌ها بررسی شد. در این پژوهش چهار تیپ ممرز- بلوط سفید (1100 تا 1400 متری از سطح دریا)، ممرز- بلوط سفید- کرب- ون (1400 تا 1500 متری از سطح دریا)، ممرز- بلوط سفید- کرب (1500 تا 1650 متری از سطح دریا) و ممرز- اوری (1650 تا 1725 متری از سطح دریا) در طول گرادیان ارتفاعی شناسایی شدند. بیشترین تعداد در هکتار (توده‌های بالغ و زادآوری) و میانگین رویه زمینی درختان در تیپ ممرز- اوری و بیشترین میانگین قطر برابر سینه در تیپ ممرز-بلوط سفید مشاهده شد. بیشینه فراوانی زادآوری دانه‌زاد نیز در تیپ ممرز- بلوط سفید- کرب دیده شد.}, keywords_fa = {ارسباران,زادآوری,فیزیوگرافی,گرادیان ارتفاعی,ویژگی‌های کمی و کیفی}, url = {https://ijfpr.areeo.ac.ir/article_107390.html}, eprint = {https://ijfpr.areeo.ac.ir/article_107390_7e20db04093349c86c02795e376dd033.pdf} }